Knighty_almighty

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Cutting the Pices

With a jigsaw, circular saw it a basic hand saw cut out all the pieces required. Use the picture to judge how big they are.

Step 2: Sanding

Sand each individual price with 130 then 80 grit sandpaper either by hand or with an electric sander.

Step 3: Glueing/screwing Drilling

Drill holes in each support that need to be drilled and then glue the required pieces together and then drill some pilot holes and counter sink them. Screw them together.

Step 4: Finilizing

Push the threaded rod into the pre-drilled holes and and widgets on either end of the rods. Attach a nut on rather end as well as a butterfly bolt.

DIY University Contest

Participated in the
DIY University Contest

Share

    Recommendations

    • Indoor Lighting Contest

      Indoor Lighting Contest
    • Metal Contest

      Metal Contest
    • Make It Fly Challenge

      Make It Fly Challenge

    5 Discussions

    0
    None
    Susitna

    4 years ago

    I think I would like to use that arm to hold a needlework frame. I have been looking for a compact, portable device that could hold a needlework frame so that I could continue to embroider while recovering from hand surgery.

    0
    None
    will-knight

    4 years ago

    Thanks for the tips I'm new to this and not to see how to use it but I will add a few more pictures

    0
    None
    seamster

    4 years ago on Introduction

    Hey, this looks nice!

    This would really benefit from some photos and description showing how you made it. Even a descriptive title and a little information in the intro would be great.

    It looks interesting, and I think people would like to see how it was made. Just a couple tips! :)