LCD 3D Printer Daylight Resins

Published

Introduction: LCD 3D Printer Daylight Resins

LCD 3D Printer V4

My version of the printer with LCD screen and Daylight Resins.

Step 1:

How it is built:

Step 2:

How prints:

Step 3:

What can do:

Step 4:

Hardware:

- Raspberry PI 3

- LCD 5 inch 800x480 HDMI

- Drivers A4988 (Microstep=4)

- Stepper+threaded rod

- Matrix LED + controller (http://www.tme.eu/ro/details/osb56lze31d/led-uri-tht-super-flux/optosupply/)

- power supply 5v 12V

- two metal rods - magnets (HDD)

- Endstop

Software:

- NanoDLP

- mode Movement GPIOs Parameters:

- x/y 0.135mm

- Layer Thickness = 0.025mm

- Cure Time = 2 seconds - Lift 2mm

- Daylight Resins (http://photocentric3d.com/)

Share

    Recommendations

    • Oil Contest

      Oil Contest
    • Water Contest

      Water Contest
    • Clocks Contest

      Clocks Contest

    3 Discussions

    0
    user
    wjtarr

    1 year ago

    Do you have any other info on the build or video of it working.

    could be possible use a biger monitor??

    That's neat :)