LED Bar Graph

2,899

4

2

Introduction: LED Bar Graph

this led bar graph contains only three LED s and each LED show the low, mid range and high frequencies according to the audio played, this bargraph can be used in audio amplifiers, the circuit is for a 40w amplifier,  connect the circuit in parallel to the speakers and no external power supply is needed........

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Parts List

1 x red LED ( or any color you like)
1 x Blue LED (or any color you like)
1 x Green LED (or any color you like)
1 x 1uf capacitor (electrolytic) 16v
1 x 3.3uf capacitor 16v
1 x 4.7uf capacitor 25v 

Step 2: Circuit Diagram

make the circuit according to the circuit diagram

Step 3: Conclusion

hope you like the circuit... And please rate it

Make It Glow Challenge

Participated in the
Make It Glow Challenge

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge
    • Finish It Already Speed Challenge

      Finish It Already Speed Challenge

    2 Discussions

    0
    UmerJavaid
    UmerJavaid

    8 years ago on Introduction

    what is the working principle of the circuit? correct me if i m wrong.
    when high frequency comes then the capacitor gets short (theoretically) then all LED's should glow simultaneously. and in case of low frequency no led should glow

    also what is the voltage rating of the capacitors?

    0
    sooraj619
    sooraj619

    Reply 8 years ago on Introduction

    since the values of the capacitors are different all leds will not glow simultaneously