LED Studded Bracelet Project, No Soldering! - Experiment

Introduction: LED Studded Bracelet Project, No Soldering! - Experiment

I wanted to see if I could create a LED studded leather bracelet that functioned well and was somewhat attractive. I used scrap watch parts, light grey leather, 10 red LED's, a low ohm resistor, E6000 and machine stitched it all up with conductive thread.


materials:
leather or leather bracelet
LED's
conductive thread
good sewing machine
hand needles
e6000 glue
low-ohm resistor
Li Po battery, small size
watch band parts
awl, leather hole punch

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Jewelry Contest

Participated in the
Jewelry Contest

Be the First to Share

    Recommendations

    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Raspberry Pi Contest 2020

      Raspberry Pi Contest 2020
    • Wearables Contest

      Wearables Contest

    Discussions