Laboratory Water Distiller

Introduction: Laboratory Water Distiller

To construct a distiller, individual parts are developed in SolidWorks drawings based on design calculations and dimensions.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Design the Distiller

Make your initial design in SolidWorks

Step 2: Start With the Base

Put your base on the working table

Step 3: Attach the Liner

Attach the boiling tank liner with the base

Step 4: Add the Back Cover and the Top Cover

Slide the back cover, top cabinet , switch,electrical wired

Step 5: Top Cover

Cover the top of the unit with top cover. Slide in the door and the middle divider.

Step 6: Distiller Unit Complete

Be the First to Share

    Recommendations

    • Magnets Challenge

      Magnets Challenge
    • Snow Challenge

      Snow Challenge
    • Wearables Contest

      Wearables Contest

    Discussions