Laser Engraved Diy Rubberband Shooter

Introduction: Laser Engraved Diy Rubberband Shooter

Looking online, the designs were either crappy looking or made too complicated. I combined both ideas, and so far in my research, nobody has done it like this before.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Why?

Looking online, the designs were either crappy looking or made too complicated. I combined both ideas, and so far in my research, nobody has done it like this before.


Step 2: Tools and Supplies

1x6 board
Clothes pin
Jigsaw
Wood glue
Drill
Drillbit or 1 inch spade bit
Router

Step 3: How

I traced a B.B. gun. Cut it out with jig saw.
Drilled out area for trigger and routed slot above for clothes pin.

Step 4: Final Step

After I sanded everything down, I lasered grips on the handle.


Video can be found on YouTube by searching “Laser engraved Diy rubber band shooter”
https://www.youtube.com/watch?v=KIbW0gJooAA

Be the First to Share

    Recommendations

    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Rope & String Speed Challenge

      Rope & String Speed Challenge
    • Wearables Contest

      Wearables Contest

    Discussions

    Cool. I wish that I had a laser engraver. I would make stuff like this all the time.