Laser Trip Wire With Breadboard

Introduction: Laser Trip Wire With Breadboard

Laser trip wire made with breadboard and laser.

On your door when someone walks in so they get scared. For robbers and criminals.

My door doesn't have a lock so an alarm would be great for my door. After trying this with arduino the code was messed up so i found out a different way. this way was much simpler and actually worked.

Some problems I had was the alarm and light would go on no matter what and the code for my origanal trip wire didn't work

Supplies:

COMPONENTS REQUIRED:- LDR, L.E.D, BC547 Transistor, 100k ohm resistor, 9v Battery, Buzzer & Breadboard, laser.

Step 1: Step 1

Connect all the wires to the breadboard and the battery.

Step 2: Step 2

Aim the laser at the sensor and when you interfere with the laser the alarm will go off.

Be the First to Share

    Recommendations

    • Lighting Challenge

      Lighting Challenge
    • Colors of the Rainbow Contest

      Colors of the Rainbow Contest
    • Puzzles Speed Challenge

      Puzzles Speed Challenge

    Discussions