Hello! guys today i'm gonna show you how to make 8 mode led chaser using 12f629 8 pin (PIC IC).
so lets get started.
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Circuit Diagram
Here it is the circuit diagram. I just found it on google at this site www.josepino.com. I just simply save it and build a chip on vero board.
Step 2: Components
Soldering iron with solder
IC: 12f629 (PIC) with base
1 push button
Resistors: 10k and 1k
Zener diode 5.1 volt
9 volt battery
Step 3: Component Placing
Simply place the components on vero board according to circuit diagram.
Step 4: Soldering
Soldering your components i make a solder track because its efficient and better than any other soldering.
Step 5: Finish
Now your led chaser is ready to use with 8 different patterns.
Source code available on next step.
Step 6: Source Code
Here it is the source code you just simply download and upload into your (PIC 12f629 IC). Make sure IC is not working without source code.
Step 7: 8 Mode Led Chaser
Now enjoy your different leds running mode.
Participated in the