Led Lamp





Introduction: Led Lamp

Firist of all, sorry my english.
In this "post" i will show how to make a led lamp.

Step 1: Need This:

1- 3v baterry
2- LED
3- Electrical tape
4- Part of CLIPS

Step 2: Making

Firist put the low part of LED in the side negative of baterry and will put the electrical tape, look the images. The high part dont will touch in the baterry.

Step 3: Finish

Put the leverage, just like the picture and put the electrical tape again. Yeah!!! Is finish. Now move the leverage to front for this work. The leverage in contact to baterry will bring energy to the LED and complete the system. It all.

Step 4: MOD Using the Lamp

For make a desk lamp.

Step 5: More

Use the double-sided tape in the baterry toput in the cover. Oh, dont forget of make a hole in the cover!!! and is just it. The leverage need stay in the hole.



    • Water Contest

      Water Contest
    • Oil Contest

      Oil Contest
    • Clocks Contest

      Clocks Contest

    9 Discussions

    use a resistor in series. you won't lose your fingers, but they do get pretty hot and pop (they pretty much break in half)

    I see this is your fist Instructable. This is a project that most of the users on Instructables know... A simple and effective way to get light when the power is out... The pictures are good to... But, to get featured and to get the interest of people, you have to realize your own idea. I like the on/off way...the way you solved the problem. You obviously have the potential to make something good! Keep up the good work! for now rate: 3/5 :)

    1 reply