Introduction: Lego Cyclops
Step 1: Laser
This is 3 studs wide and has a flat piece on the end. The length is up to you.
Step 2: Head
This is a yellow 3 by 2 block with three black inverted stud pieces above it. It is all topped off with a black flat 3 by 2.
Step 3: Body
The body is quite complicated. The easiest way to understand is to look at the pictures.
Step 4: Arm #1
Again, it's easiest just to follow the pictures.
Step 5: Arm #2
This is a 4 by 2 brick with a 4 by 1 and 3 by 1 brick on top.
Step 6: Leg #1
This is just like all the other legs for my other superheroes, just shorter.
Step 7: Leg #2
This is two seep rate pieces. A stack of two 2 by 2s with an inverted 2 by 2 on the bottom. The other part is a 4 by 2 brick.
Step 8: Finished!
Please favorite and comment. Tell me what I should do next.
Participated in the
Epilog Challenge VI