Lever Action Rifle

6,953

38

102

Introduction: Lever Action Rifle

ok so some people have been asking me to post so here it is so if you want to build it then get cracking

!! WARNING USES CUT PARTS !!

video here on how to load and showing it shooting

http://www.youtube.com/watch?v=rSss1Q3T4NQ

also please post your pictures of your versions and ill add them to thhe intro page

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Main Body

very easy ill add notations if needed

Step 2: Handle and Trigger

same again just follow very easy

Step 3: The Lever Bit

same again

Step 4: Stock

same again just follow pics

Step 5: Banding the Gun

easy just follow

Be the First to Share

    Recommendations

    • Toys and Games Challenge

      Toys and Games Challenge
    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge

    102 Discussions

    0
    knexmaster9
    knexmaster9

    5 years ago

    You shod make the lever pull back the fireing pin, I am going to tri it in my Spenser rifle I am going to build

    0
    knexguy237
    knexguy237

    6 years ago on Introduction

    Can you technically stop building before the stock?....I think it looks better without it.

    0
    knex mad
    knex mad

    Reply 6 years ago on Introduction

    yes you could just remove the stock and round the handle into itself would be like a shotgun in length would be pretty cool :)

    0
    sammalla99
    sammalla99

    7 years ago on Introduction

    Need a video please send me one of how to shoot it and load it :)

    0
    DracoUltima
    DracoUltima

    9 years ago on Introduction

    I built it, it's AWESOME! However, does every good gun have a part of all those blue rods sticking out? Is there a single good gun that does not have all those rods sticking out? Well, except for the SRV2.

    0
    knex mad
    knex mad

    Reply 9 years ago on Introduction

    no not at all this gun was mainly based on the main feature with the lever bit but many guns use a system which does make it flat on the outside i have done a couple my self and just so you know i am actually in the procces of improvinng this gun further i think thats just a lucky comment :)

    0
    immaturespartan117
    immaturespartan117

    Reply 8 years ago on Introduction

    hey, try putting your revolver piece in the place that you load bullets in = lever action revolver

    please try to build this, what if you replaced the part that comes out of the gun and put a revolving thing? = lever action revolver

    0
    MegaMetal8
    MegaMetal8

    8 years ago on Introduction

    Yo, I might build this soon um what are the cut parts? how do you load it? is there a mag?

    0
    The Nomlack
    The Nomlack

    9 years ago on Introduction

    I love it!!!!!!! its amazing; other than the cut parts 5* Heres mine:

    IMG_0281.JPGIMG_0282.JPGIMG_0283.JPG
    0
    KnexKrazed
    KnexKrazed

    9 years ago on Introduction

    can you use gray end connectors instead of using the broken pieces?

    0
    firefox0070
    firefox0070

    9 years ago on Introduction

    This is madd cool! its not like a repeating rifle its like a sharps where it loads from the back using a lever.