Linkit ONE Baics: Audio Buzzer

1,553

20

Introduction: Linkit ONE Baics: Audio Buzzer

Makes Basic melodies

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Materials

1kohm Resistor

Buzzer

Linkit ONE

Breadboard

Wire

NPN transistor

Step 2: Step 1: Connecting

First connect the buzzer, transistor and resistors. Follow the picture above.

Step 3: Connecting Continued

On the Linkit ONE connect these three wires. Color doesn't matter but i recommend using different colors to keep as organized as possible

Step 4:

Connect the wires on the Linkit ONE to the bread board. Do not inter-cross them.

Step 5: Connecting Con.

Add these four wires to the breadboard. Don't remove what was on it already , i did it so you could get a better view of where to put the wires. Again i advise using different color wires.

Step 6: Connecting Finish

This is what it should look like when you are finish.

Step 7: Coding and Finish

The code will allow the buzzer to play melodies and do a basic scale. Code: Download

If you have any questions leave a comment and please follow me

Be the First to Share

    Recommendations

    • Tiny Speed Challenge

      Tiny Speed Challenge
    • Clocks Contest

      Clocks Contest
    • PCB Design Challenge

      PCB Design Challenge

    Discussions