Introduction: Little Bits Speaker
Little bits power module and cord
Little bits wire
Little bits speaker module
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Get a Cup
Get a cup
Step 2: Cut a Hole
Cut a hole big enough for the speaker module
Step 3: Put Duct Tape Over the Hole to Protect the Wires From Getting Cut.
Step 4: Speaker In
Put the speaker module in the big hole. Than remove the speaker module from the it's holder. Than put the holder through the hole.
Step 5: Duct Tape Hole
Put duct tape over the ramping gap to keep the speaker module in
Step 6: Wire
Put your wire onto the speaker holder
Step 7: Power!!!!!!!!!!?
Connect the power module to the wire.
Step 8: Aux Aux Baby!
Connect the us cord to your phone.
Participated in the
Amps and Speakers Contest 2016