Lumos! - Adding Some Punch to Your Harry Potter Wand!

18,301

15

11

About: With 21 Featured Instructables, and Over 1 Million Views, I think I am doing pretty good here, with my wacky ideas!

Step 1: Video


Step 2: Assorted Random Comments

To keep the heat down at the tip, I wrapped the bulb with Teflon tape, as a heat insulator.
I took aluminum foil, and used it as a base layer, to give the wand a textured surface.
I plan on ripping apart this wand, and make a much better (looking) version

Share

    Recommendations

    • Organization Contest

      Organization Contest
    • Warm and Fuzzy Contest

      Warm and Fuzzy Contest
    • Paper Contest

      Paper Contest

    11 Discussions

    Please post instructions on how to build this, it is so much better than the other instructions I have read

    0
    None
    macgeekkinghaider

    Reply 9 years ago on Introduction

    I have gutted the wand, and am re-doing it with some of the tricks I have learned.
    I will post improvements once I finish them

    jonatahn

    0
    None
    kinghaidermacgeek

    Reply 8 years ago on Step 1

    are u done with ur wand yet??.. n if u dont.. good luck with ur new wand