Magnetic Minecraft Blocks

1,938

16

7

Introduction: Magnetic Minecraft Blocks

About: I love Arduino and Raspberry pi and High Voltage... i build robots and also other cool stuff so stay tuned !!

Minecraft is a very fun game as it allows you to build anything, this project brings that experience to the real life. Play minecraft in real life and build whatever you want.

Step 1: Materials Required

1. Block templates (To be printed)

2. Cardboard (I just used a shoe box)

3. Neodymium magnets

4. Glue

Tools Required

1. Glue Gun

2. Printer

3. Scissors or hobby knife

Step 2: Cutting the Templates

Download and print the given templates and start cutting them with a pair of scissors or a hobby knife. Also cut the side tabs, we don't need them.

Step 3: Cutting Cardboard

We will need 6 cardboard squares for every cube. Create a grid of squares with every side of 2.6 cm and cut them out.

Step 4: Sticking the Carboard

Stick the cardboard squares fairly in the center to every side of the template using glue.

Step 5: Magnetic Orientation

Now for the difficult part. We can't just stick magnets in any orientation, as we all know the same poles repel and opposite poles attract each other. I found this to be an optimal placement -

North - Top, Right and Left

South - Bottom, Front and Back

(This is the polarity from the outside, meaning this the side you have to stick to the cardboard)

To find out the polarity of a magnet just bring it near a compass, I used the compass in my phone.

Step 6: Closing It All Up

Using a glue gun, glue every side and to glue the last side just apply some glue on the edges and close it. Now your magnetic minecraft blocks are ready !!!

Have fun and if you liked my instructable then vote for it in the contest :)

Minecraft Challenge 2018

Runner Up in the
Minecraft Challenge 2018

Epilog Challenge 9

Participated in the
Epilog Challenge 9

Paper Contest 2018

Participated in the
Paper Contest 2018

Be the First to Share

    Recommendations

    • Mason Jar Speed Challenge

      Mason Jar Speed Challenge
    • Pumpkin Challenge

      Pumpkin Challenge
    • Halloween Contest

      Halloween Contest

    7 Discussions

    0
    Gadisha
    Gadisha

    Tip 2 years ago

    ... or stick the magnetic paper on the back (in different directions as the magnets above) if you don't just want to stick them on the fridge but to each other lol

    0
    Gadisha
    Gadisha

    Tip 2 years ago

    You could probably also print these on magnetic photo paper.

    0
    610039228
    610039228

    2 years ago

    This post was for three contests?! You just hit three birds with one stone, my friend.
    Good job.

    0
    Arduino Tech
    Arduino Tech

    Reply 2 years ago

    Thanks a lot

    0
    Arduino Tech
    Arduino Tech

    2 years ago

    They would be even better if I could make a lot of them with a 3d printer. But I do not have one

    0
    Penolopy Bulnick
    Penolopy Bulnick

    2 years ago

    These would be so much fun to play around with! I could distract myself forever if they were sitting on my desk :)