Make a Bind Plug

6,908

12

2

Introduction: Make a Bind Plug

A Bind plug is used for binding a Transmitter with a Receiver. Most of the time I used to lose my bind plug. It may be cheaper to buy, but the shipping time will be the problem. So let's make one

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Gather the Supplies

Step 2: Cut the Female Header Pin

Step 3: File the Edges of the Header Pin

Step 4: Make Sure It Fits to the RX

Step 5: Hold It

Step 6: Strip Both Ends of the Wire

Step 7: Add Flux to the Joints

Step 8: Solder

Step 9: Remove the Center Pin (optional)

Step 10: Shrink It

Step 11: There You Have a New Bind Plug Made by Yourself. Enjoy Flying!!!!

Epilog Contest 8

Participated in the
Epilog Contest 8

Trash to Treasure Contest 2017

Participated in the
Trash to Treasure Contest 2017

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge
    • Arduino Contest 2020

      Arduino Contest 2020

    2 Discussions

    0
    AndrewF178
    AndrewF178

    3 years ago

    This Instructable could use some explanation of what a bind plug is and what its purpose is. I used to fly RC and I work in electronics, but I'm none the wiser what this is.

    0
    chrisjlionel
    chrisjlionel

    Reply 3 years ago

    Bind plug is a simple jumper used to bind Tx and Rx. But nowadays Rx were coming with a Bind switch.