Introduction: Make a Car in Little Big Planet!! :)
Hi hello and welcome to my first instructables instruction thingy I have made. ;D
Have you wondered how to make a car in Little Big Planet? Well I did too and I will share with you the instructions on how to build this wonderful thing. So lets get to it!!!!!!
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: The Body
OK first go in to goodies bag were you will find basic wood. Place it in a semi-circle shape as shown in the pictures above.
Step 2: The Wheels
Then place two rubber circles in front of the wood.
NOTE : make sure that the bottom of the wheel is lower then the wood :3
Step 3: The Cabin
Cut out a small hole for you to drive in.
Then place a small bit of sponge inside the hole, the sponge will be the throttle
Step 4: Motor VVVOOOOOOOOOMMMM
Here you want to go in to the tools bag and select the motor bolt and place it right in the center of the wheel
Step 5: Throttle and Again, VVVRROOOOOOMM
Go back in to the tools bag and select the grab sensor.
Place the sensor on the sponge that you placed in the cabin. Then go into the popit courser and place it right by the right side of the sensor. Move the courser around until you see a green light pop up, you might have to zoom in to see it. Click on the light, when you click on it you should see a wire come out. Drag it to the motor bolts and place it there.
Step 6: Testing
When you are done jump on in the car and press R1 to grab the sensor. Have a safe trip!!