Make a Connector Body

Introduction: Make a Connector Body

About: I also go by the Instructable user name: UnknownUser2007

Here is a quick way to make a connector body.

Use a pen cap and saw it in half. Then fill both halves with hot glue and enclose them around the connector. Makes a great connector body that helps keep the strain away from the solder joints.

This technique can also be used for a cable splice. Use a pen body instead of a cap.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Be the First to Share

    Recommendations

    • Magnets Challenge

      Magnets Challenge
    • Raspberry Pi Contest 2020

      Raspberry Pi Contest 2020
    • Wearables Contest

      Wearables Contest

    3 Discussions

    0
    threewheela
    threewheela

    5 years ago

    nice track saw! do you model railroad?

    0
    TheDeviant13
    TheDeviant13

    10 years ago on Introduction

    I am going to try this with a 2 gig flash drive Five stars.