Make a USB Switch

2,586

14

4

Introduction: Make a USB Switch

About: Hello, I am 17 year old innovator living in India. My interest lies in Electronics. Surf through my creations and enjoy!!!!1

Here presented instructable will guide you to the step by step instructions to make your own DIY USB Switch.

This USB Switch will take the power from USB and will power on the Relay.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Get This Quick!

1. 4 pin connector

2. BAT 85 Diode

3. 100uF Capacitor

4. 1N4148 Diode

5. 5v Relay

6. 2 pin connector

Step 2: Circuit Diagram

Presented here is the circuit Diagram for the USB Switch.

Step 3: Step 1

Place the 4 pin connector for the USB connection on the breadboard.

We will take the voltatge from the first and last pin of the connector.

Step 4: Step-2

Place the BAT-85 Diode in such a condition that the positive terminal of the diode will be connected to the first pin of the connector.

Step 5: Step-3

Place the 100uF capacitor in such a way that the positive terminal of the capacitor will be connected to the negative terminal of diode and the neagtive terminal of the capacitor to the last pin of the connector.

Step 6: Step-4

Now, Connect 1N4148 in such a way that its positive terminal is connected to the positive terminal of the Capacitor and the negative terminal of diode to the last pin of the connector.

Step 7: Step-5

Now Connect the connector for the output of the relay. Fro the positive terminal of the capacitor and the last pin of the connector.

Makerspace Contest 2017

Participated in the
Makerspace Contest 2017

Be the First to Share

    Recommendations

    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Raspberry Pi Contest 2020

      Raspberry Pi Contest 2020
    • Wearables Contest

      Wearables Contest

    4 Discussions

    0
    garys6
    garys6

    2 years ago

    Not sure I see a use for this besides turining on some higher current device when you power on a computer

    0
    Patel Darshil
    Patel Darshil

    Reply 2 years ago

    Perfectly said!!!!!

    0
    AshwinC6
    AshwinC6

    2 years ago

    What is the use of this? Better give some circuit with software control to make relay ON and OFF!

    0
    msameer39
    msameer39

    2 years ago

    Nice idea bro