Introduction: Make a Simple Arduino Code
We will make a simple code that turn on the led and wait for 1 second
then turn off the led and wait for 1 second
Step 1: Step1: Parts We Need
1-any arduino but for this example use Uno
2- wires male-male but you can connect the led directly to arduino
3- Bread board
4- led
5- any resistance you need like 1K ohm or 330 ohm
Step 2: Step2: Connect the Resistance to Led
connect the resistors to the tallest pin in led
Step 3: Step3: Connect the Led to the Arduino
then connect the pin that we connect the resistors to the pin 13
and the other pin to the ground
Step 4: Step4: Then the Arduino Cod
we will see the comments that describe the functionality of the code
Attachments
Step 5: Step5: Finally
We finished
I hobe that you enjoy
and i make you to love arduino more