Introduction: Make an Industrial Wooden Christmas Tree
I am big on recycling and repurposing things. I’m always willing to
think outside the box. Traditional Christmas trees are naturally beautiful and smell amazing. And yes, I do opt for a real tree every year. But this year I wanted to add something that was a little different to my Christmas decorations. I had been seeing pictures online of these crazy expensive “stick trees” that cost way to much. I mean I loved the concept, just not the price. I guess this year I was in a bit of a Charlie Brown spirit given the new Peanuts movie. I also wanted to incorporate some metal into the make of the tree to give it an industrial flare. In keeping with my “use what you’ve got” philosophy, I decided to accept the Scrap wood challenge by SawdustGirl, Sandra, in which you use only scrap wood to build a project.
So I created a wooden tree using scrap wood from my workshop and nuts and bolts. Here’s what I did.
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Supplies & Cut List
3/8-in Threaded Rod 2 Feet
3 – 1x2x82×2
50 – 3/8-in Washers
30 – 3/8-in – 16 Hex Nuts
20 – 13/16 Screw eyes (optional)
Wood stain or paint
1 1/4″ Construction screws
Step 2: OK Let's Get Dirty!
Start by sanding and staining the wood.
After you've cut the 1×2 pieces for the branches and the 2×2 for the base of the tree we are ready to get started.
Sand the pieces using a medium followed by a fine sanding paper. The last thing you want is a Christmas tree that gives splinters.
Stain the pieces the color of choice.
To speed up the drying process I spray the stained wood with a clear shellac.
Step 3: Assemble the Base of TheTree
The base of the tree is made using the 2×2 pieces. Using pocket screws and wood glue attach the two smaller 2×2 pieces to the larger central piece.
Step 4: Center of Tree
Next drill a hole about and inch deep into the center to the base for the insertion of the 3/8-in Threaded Rod
Use a drill bit wide enough to secure fit the all thread without leaving it loose when screwing it down into the base. For additional strength and support use Gorilla Glue on the thread and in the hole.
Step 5: Drill
Allow time for the glue to dry securing all thread into the base of the
tree. While its drying drill a hole at the center of each 1×2 branch piece.
Step 6: Build the Tree
Now here’s where patience comes into play…. starting with the largest piece of 1×2 (16-in), place it on the all thread. Follow it with the washer then hex nut then another washer. Repeat with the next largest piece of 1×2 (15 1/2-in.)
Now this process drove me literally insane. I kept thinking I’m glad I didn’t get an all thread that was larger than 2 feet. Screw the nut to each section so that the “branch” is snug but still able to be moved by hand.
I had to take a few breaks so not to cramp my hands.
But once it once I’d finished I celebrated with a huge glass of eggnog (maybe it was spiked…maybe it wasn’t). Either way it got the job done.
But move the 1×2 pieces to reflect branches.