Making a Keyboard Enclosure

Published

Introduction: Making a Keyboard Enclosure

About: Learn electronics and Arduino with Tinkercad Circuits!

The following information is a single lesson in a larger project. Find more great projects here.

Return to Previous Lesson: Writing the Code

Lesson Overview:

Now we'll make an enclosure for our instrument!

Step 1: Cut Out the Template

Now that the electronics and code are complete, it's time to think about an enclosure for the keyboard. While old analog synthesizers had wires poking out all over the place, your keyboard is sleek and digital. Prepare a small piece of cardboard that can be cut out to accommodate your buttons. Label the keys, so you know what notes are triggered by each key. You can use the picture and instructions below as a guide.

Now you have a more realistic looking instrument! Enjoy your creation!

  1. Draw and cut a piece of paper with holes for the four buttons and piezo. Decorate it to look like piano keys.

  2. Position the paper over the buttons and piezo.

Congratulations, you have completed this project!

Check out other great projects here.

Share

    Recommendations

    • Creative Misuse Contest

      Creative Misuse Contest
    • Water Contest

      Water Contest
    • Clocks Contest

      Clocks Contest

    Discussions