Mechanical Endstop Switch

Introduction: Mechanical Endstop Switch

Of course you can buy it, and it is not so expensive. But it is so simple and you can make it by yourself.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Parts

To build this mechanical end-stop switch you will need :


1) 1x micro switch roller lever eBay

2) 1x 10k 0805 resistor

3) 1x 120R 0805 resistor

4) 1x 0.1uF 0805 ceramic capacitor

5) 1x led 1206

6) 0R 1206 jumper ( resistor)

7) copper board or perforated breadboard

Step 2: PCB Board and Schematic Diagram

Design printed circuit board (PCB), I was used ,,Sprint-Layout" software.

Step 3: Done

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge
    • First Time Author Contest

      First Time Author Contest

    Discussions

    0
    BeachsideHank
    BeachsideHank

    3 years ago

    A nice clean layout, I like it. ☺