This is a mini pencil that works. Its made of a toothpick and a 0.7 lead.
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: First Step
Take one toothpick and cut both ends with the cutter-knife.
Step 2: Step Two
put the toothpick on a flat surface and cut it along
Step 3: Step Three
With the cutter-knife and the pin, carve the center. (here will be the 0.7 lead)
be very patient... and smile as you do it.
Step 4: Step Four
once the draft is the center of the pen, enter the 0.7 lead and paste it with glue.
you must have a very firm hand. cut the excess of lead.
Step 5: Sharping the Pencil
Sharp the tip of your pencil with the cutter-knife.
See if it writes and paint it yellow.
you can sand the end for a better look.