Money Magic

Introduction: Money Magic

Schematic

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1:

First you will need: Three LEDs, a resistor, some cardboard, wire, a 9V battery, and some conductive marterial.

Step 2:

First you will weld the three LEDs to the resistor and the positive side of the battery

Step 3:

Then you will pick holes in the cardboard so only the LEDs are visible.

Step 4:

Then attached the bent cardboard to the sheet and attach the conductive material to the spoon and sheet of cardboard.

Step 5:

Finally, let money on the spoon to complete the circuit and light up the LEDs.

Be the First to Share

    Recommendations

    • Finish It Already Speed Challenge

      Finish It Already Speed Challenge
    • Arduino Contest 2020

      Arduino Contest 2020
    • First Time Author Contest

      First Time Author Contest

    Discussions