NAPKİN HOLDER (MOBİLE CHARGİNG CENTER)

Introduction: NAPKİN HOLDER (MOBİLE CHARGİNG CENTER)

I make this product specially for cafe and restaurants. İt includes a powerbank which has 12000 MA cappacity and two outputs(2,1A and 1A). So you can charge your phone, tablet, laptop etc. during drinking your coffee.

Today charge of our phones is very important.

I wil explain how ı made ıt ın steps wıth photos and videos. You can look and you can make yours.

I wıll share ıts project ın dxf and pdf file format.

Fırst of all ı design ıt on Corel Draw. Than ı cut ın laser cutting machine. I use 2.7mm Mdf. After fınıshed cutting step, ı combine pieces with super fast glue. I show each piece on photos.

Finally ıts ready to use...

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: DESİGN PROCESS

Step 2: LASER CUTTİNG PROCESS

Step 3: COMBİNE PROCESS

Step 4: ITS READY FOR USE

Step 5: DESİGN FİLE (DXF and PDF)

Step 6:

Epilog X Contest

Participated in the
Epilog X Contest

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge
    • Finish It Already Speed Challenge

      Finish It Already Speed Challenge

    2 Discussions

    1
    randofo
    randofo

    1 year ago

    Practical idea. Thanks for sharing with us.

    0
    Epcane
    Epcane

    Reply 1 year ago

    Thank you so much for your kindness. I wıll contınue to share my designs on İnstructables.