NES Controlled Etch-A-Sketch



Drawing on an etch-a-sketch using an original Nintendo controller. I connected the etch-a-sketch knobs to stepper motors, which are then controlled by an Arduino microcontroller. The Arduino program I wrote takes signals from the NES controller and sends them as stepper motor control instructions.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Be the First to Share

    Recommendations

    • Made with Math Contest

      Made with Math Contest
    • Multi-Discipline Contest

      Multi-Discipline Contest
    • Robotics Contest

      Robotics Contest

    2 Discussions

    0
    None
    alpinedeltaBongmaster

    Reply 7 years ago on Introduction

    Sorry everyone, there seems to be issues with the uploader. I can't edit the instructable either. Here is the video on YouTube:

    http://www.youtube.com/watch?v=WCkh4s1q1WQ