NYS Contour Map Ornament

This is a contour map of New York State that I made into a tree ornament.

The map was originally larger. Some of the contour lines get a bit thin at this size. I put a 2mm sheet in the middle of the ornament to stiffen it. This creates some overhangs that can be difficult for some printers. The bottom may wind up a little rougher than the top. There is a hole in the northern part of the ornament to hang it. The .stl prints as a single object.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Be the First to Share

    Recommendations

    • CNC Contest

      CNC Contest
    • Teacher Contest

      Teacher Contest
    • Maps Challenge

      Maps Challenge

    Discussions