Cardboard Nerf Belt

Introduction: Cardboard Nerf Belt

About: Hello, I make stuff.

Hello Instructables users,

This is how to make a nerf ammo belt out of cardboard.

This is for the cardboard challenge.



This is what you'll need
-Marker
-Corogated cardboard
-Thin cardboard(cereal box)
-duct tape(color does not matter)
-Scissors
-Ruler
-Nerf dart(for size)







Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Getting Started

Measure your dart, when I measured mine it was 3X1/2 inches


Now cut the cardboard to a good working size and bend cardboard around darts one at a time.
Till you get like picture 1.

Do untill out of cardboard or when boredom sets in, for this i will make 7.

Step 2: Backboard


Now, get another peice of cardboard like this(picture 1) thats 8 inches long and duct tape the loops on.(picture 2)


P.S yours will look better than mine I'm not good with tape

Step 3: Strap

Now get your thin card board and cut 2-3 strips the size of belt and tape to back.

Step 4: Your Done!

Now put it on and start the battle!



Be the First to Share

    Recommendations

    • Sculpting Challenge

      Sculpting Challenge
    • Trash to Treasure Contest

      Trash to Treasure Contest
    • 3D Printed Contest

      3D Printed Contest

    7 Discussions

    0
    builderkidj
    builderkidj

    Reply 8 years ago on Introduction

    You put your darts in to reload so you dont have to shove into your pockets.