Nerf Electronic Gun!

6,183

3

15

Introduction: Nerf Electronic Gun!

About: Tsc stands for totallysupercreaitve. Please if you like what I make follow me! I like riding any thing with a engine or motor. I also like build weedeater bikes and chainsaw bikes also mini choppers. I ...

Ok now  this instructable I will show you how to make your nerf gun look cooler. I'm enter this in to the usb  contest so please vote for it!!!! If you like what I build please subscribe to me!!!!

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Things You Need!

Stuff you need:
Broken electronics (you will need at least one broken flash drive)
Hot glue gun,(with glue sticks)
Some thing that will cut, 
A nerf gun,

Step 2: OK!

OK! now take apart  your broken electronic all you need is the  circuit board.

Step 3: Glue

Now glue The flash dive on your nerf gun by the nerf bullet holder.

Step 4: Just

Just glue your electronics were they bast fit  cause  I do not think we will have the same electronics.

Step 5: Nerf Bullets

OK now take off the black stuff at the end of the nerf bullet  and put hot glue in the hole make sure that it is   compete  cover so, no air comes through it.

Step 6: The Trigger

Ok, now trace  the hole size of were the trigger hole is on to the circuit and cut  out the hole, repeat  this  step with a other circuit board.Look at the picture and notes.And glue it over the trigger spot.

Step 7: Wires!

OK take your wires and glue them were you want them I glue my to one side of the gun to the other side look at picture.

Step 8: Top!..

Look at picture.

Step 9: Done!!!!

OK look at the picture sand your edges  down and your done!!!!!!!

Participated in the
USB Contest

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge
    • Finish It Already Speed Challenge

      Finish It Already Speed Challenge

    15 Discussions

    0
    TSC
    TSC

    Reply 9 years ago on Introduction

    It has a flash drive on it!!!!!!!!

    0
    TSC
    TSC

    Reply 9 years ago on Introduction

    Lol!

    0
    zack247
    zack247

    Reply 9 years ago on Introduction

    but... the contest says (kinda) that it should interact with the usb port. you said the flash drive was dead

    0
    TSC
    TSC

    9 years ago on Introduction

    The point was that it looks cool!!!!!!!!! and who said any thing abart a mother board???!