New Thinking 100

Introduction: New Thinking 100



紙板步進電機線按鈕arduino Leonardo

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Cut the Cardboard

Six cardboard 25*25 cm the up one need to have a hole 10*10 cm or it can more smaller
Four cardboard Trapezoid up 25 cm down 10 cm or smaller
Three cardboard 5*28 cm

Put stepper motor in the 10*10 hole and put the arduino material in the trapezoid and turn the stepper motor make some material drop down.

Step 2: Put Your Code

Be the First to Share


    • Magnets Challenge

      Magnets Challenge
    • Raspberry Pi Contest 2020

      Raspberry Pi Contest 2020
    • Wearables Contest

      Wearables Contest