Chopping Board

Introduction: Chopping Board

About: Joiner / carpenter by day enjoy making things

Made from left over oak flooring . Cut a section of ply to the size I wanted my chopping board then layed out blocks on 45 degree angles and marked against ply to get my angles

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Chopping Board

After I cut all the blocks to size I sanded off rough edges and glues blocks together using my piece of ply wood as my guide. After all glued I left for 24hrs

Step 2: Chopping Board

After it was left for 24hrs to settle I sanded both faces then ran the decrotive edge around the board with a router . Then to finish off drilled the hole with a 32mm hole cutter then sanders with fine sand paper

Woodworking Contest

Participated in the
Woodworking Contest

Be the First to Share

    Recommendations

    • Sculpting Challenge

      Sculpting Challenge
    • 3D Printed Contest

      3D Printed Contest
    • Motor Vehicle Contest

      Motor Vehicle Contest

    2 Discussions

    0
    lodgedog
    lodgedog

    6 years ago

    Hi I have done a write up on how it was made thankyou