Origami Usability Testing

Introduction: Origami Usability Testing

I'm going to teach you how to create an origami paper crane step by step! Enjoy!

Supplies:

paper

scissors

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Step 1

Begin with a piece of printer paper

Step 2: Step 2

Take the top right corner and fold it along the edge of the left side

Step 3: Step 3

Cut the excess piece of paper that is not folded with scissors

Step 4: Step 4

Open the folded piece of paper

Step 5: Step 5

Fold the paper along the crease that was created

Step 6: Step 6

Open the folded piece of paper to where it looks like a diamond

Step 7: Step 7

Fold the right corner of the diamond to the opposite corner

Step 8: Step 8

Unfold the paper to where it looks like a square

Step 9: Step 9

Flip the paper over

Step 10: Step 10

Fold the top right and bottom right corner to the top left and bottom left corner

Step 11: Step 11

Unfold again

Step 12: Step 12

Fold the top right and top left corners to top bottom right and bottom left corners

Step 13: Step 13

Unfold again where it looks like a diamond

Step 14: Step 14

Fold along the bottom left and right creases

Step 15: Step 15

Bring top down to create crease

Step 16: Step 16

Keep flaps on the bottom

Step 17: Step 17

Fold right side flap to center crease

Step 18: Step 18

Fold left side flap to center crease

Step 19: Step 19

Repeat steps 17-18 on the other side

Step 20: Step 20

Fold top flop down

Step 21: Step 21

Take bottom flap and crease it on the top crease you just created

Step 22: Step 22

Fold two inside creases inward

Step 23: Step 23

Crease bottom

Step 24: Step 24

Flip paper over and repeat steps 20-23

Step 25: Step 25

Take the right corner and the left corner and fold them to the center

Step 26: Step 26

Flip the paper and repeat step 25

Step 27: Step 27

Pinch both sets of flaps together

Step 28: Step 28

Take bottom corner and fold it up to the center crease

Step 29: Step 29

Flip and repeat step 28

Step 30: Step 30

Flip bottom part up

Step 31: Step 31

Fold left and right flaps down

Step 32: Step 32

Fold front flap down to make head

Be the First to Share

    Recommendations

    • Magnets Challenge

      Magnets Challenge
    • Warm and Fuzzy Challenge

      Warm and Fuzzy Challenge
    • Wearables Contest

      Wearables Contest

    Discussions