PCB DRILL

Introduction: PCB DRILL

in this you will learn about how to make a Hand drill using a 9v-12v motor.

Things you"ll need -:
1. 9v-12v motor
2. Electrical or pvc tape
3. Battery connector
4. Super glue
5. 9v battery.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1:

join the drill bit to the motor shaft with the help of tape and super glue.

Step 2:

Connect the battery with the battery conector and make sure that the direction of the motor is in correct direction.

Step 3:

Now you are ready to drill your pcb.
plzz vote.

Epilog Challenge V

Participated in the
Epilog Challenge V

Battery Powered Contest

Participated in the
Battery Powered Contest

Be the First to Share

    Recommendations

    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Raspberry Pi Contest 2020

      Raspberry Pi Contest 2020
    • Wearables Contest

      Wearables Contest

    Discussions