PCB Designing Using Fritzing

About: Electrical Engineer,DIY Hacker,Philomath,IEEEian

Fritzing is an open source initiative to develop amateur or hobby CAD software for the design of electronics hardware, to support designers and artists ready to move from experimenting with a prototype to building a more permanent circuit. It was developed at the University of Applied Sciences of Potsdam.

Also check my other Two PCB Designing tutorials
PCB-Designing-Using-EasyEDA

PCB-Designing-Using-Circuit-MakerAltium

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Schematic

Open Fritzing and click Schematic Tab

Select and drop (Battery,Push Button,Resistor_1Kohm,LED)from core parts in the schematic and connect the component using wire as per the image.

Step 2: Tracks

Click PCB Tab

Arrange the components as per the image(or keep the distance between components close)

Click Autoroute

Step 3: Copper Fill

Click Copper Fill from Core parts and drop in the PCB Layout and Save

click Export(If you are gonna Fabricate)

Share

    Recommendations

    • Indoor Lighting Contest

      Indoor Lighting Contest
    • Make It Fly Challenge

      Make It Fly Challenge
    • Growing Beyond Earth Maker Contest

      Growing Beyond Earth Maker Contest

    Discussions