PCB Smartphone Stand/Holder

3,479

13

3

Introduction: PCB Smartphone Stand/Holder

About: http://diy.viktak.com

This s my take on a DIY phone holder. Detailed instructions can be found on my web site at diy.viktak.com.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Be the First to Share

    Recommendations

    • Magnets Challenge

      Magnets Challenge
    • Raspberry Pi Contest 2020

      Raspberry Pi Contest 2020
    • Wearables Contest

      Wearables Contest

    3 Discussions

    0
    florinc
    florinc

    7 years ago on Introduction

    If you also added the connector, then it would have been a full-fledged holder/charger. Next step, add a small amplifier and a pair of speakers.

    0
    Geli12
    Geli12

    8 years ago on Introduction

    Király lett :D
    ÉS jó látni magyarokat is Instructables-ön :)