Knex Battle Rifle





Introduction: Knex Battle Rifle

This is my first knex gun. It fires up to 80 feet with two strong rubber bands. Some of the credit goes to darth gecko man for tips and also killer6 for ideas from one of his guns. Please rate my gun and comment me how i could inprove on it.

Step 1: The Stock

This is how you make the stock

2-make these
3-make these
4,5-Attach them to the side piece
6-add the other side
7-another angle

Step 2: The Handle

This is how to make the handle

2-make these
5-add the other side to it
6-add these
7-another angle

Step 3: The Magazine

The magazine holds the bullets

2-make these
5-put the other side on

Step 4: The Barrel

This is how to make the barrel

1-make this 4 times
2-add these
3-add another piece
4-put 3 blue spacers on the blue pieces
5-put the rest of the sides on
6-make this
7-attach it here
8-another view
9-make these
10-join them here

Step 5:

This is the body of the gun, it is the hardest part of the gun and the longest step

2-this is the trigger, make it
3-another view
4,6,8-make these
5,7,9,10-another view
11-add pic 6 to pic 8
13-add pic 4 to 8
14-other side
15- slide a red rod through the gap but shouldn't clip in
16-completely in
17-make this
18-should clip in here
19-put these here

Step 6: Putting It Together

attach all the parts as shown

Step 7: Loading the Magazine

load it as is shown

1-all the pieces
2-attach these pieces
4-put the ammo in
7-push it in untill it clicks
8-push the ammo in
9-put some rubber bands in

Step 8: Firing Pin and Rubber Bands

pretty easy steps

1-The firing pin
2,3-put the firing pin into the gun
4-the rubber bands
5,6-rubber band goes here
7,8,9-rubber band goes here
10,11-rubber band goes here



    • Clocks Contest

      Clocks Contest
    • Water Contest

      Water Contest
    • Stick It! Contest

      Stick It! Contest

    17 Discussions

    looks like a really cool gun i think i am going to make it

    make other version and post 1 2 3 4 5 6 7 8 9 10 and POST!!!!!!!!!!!!!!!!!!!!!!

    nvm i ran outa peices that where correct, but i added some other types to make it work =), but for the clip do u have to use ball joints, or can u use somthin else, cuz i dont have any ball joints.

    on step 5 could u add a list of peices that i need, and hpw many of them i need, cuz i dont wana have to keep goin back and forth. p.s. nice gun so far

    I just Posted a picture of me Halo 2 Battle Rifle Version 2

    Photo 49.jpg

    Nice! this is really good! 5* i will build this once i finish my current project

    I made one of theese not to long ago with a removable magazine in the back which was really cool, but you would have to change a lot to do that. I don't see anything you can change, looks real nice. 5*

    great gun, the instructions were good please tell me when you publish that car, it looks cool