PVC Light Saber

Introduction: PVC Light Saber

Today I will show you how to make a PVC light saber.

Things you will need:

at least 3 and a half feet of 1/2in pvc

1ft of "1in" pvc

pvc cutter

Red and silver paint

and electrical tape.

Step 1: "1/2"in PVC

I cut the "1/2"in pvc at 39in, feel free to cut it at any length. (Just remember that the light saber starts a foot up)

Step 2: Paint

Now is when you paint it! yay!!! go ahead and paint it your favorite lightsaber color.

Step 3: 1in PVC

Grab a foot of 1in pvc and cut a angle on one of the ends, then paint it grey.

Step 4: Tape

Decorate your handle however you like.

Then wrap tape around one of the sides of the saber until the handle slides onto it and fits tightly.

Step 5: Finished!

I made two. After a while of fighting the paint will chip off and you will have to repaint.

Halloween Props Contest

Participated in the
Halloween Props Contest

DIY University Contest

Participated in the
DIY University Contest

Teach It! Contest Sponsored by Dremel

Participated in the
Teach It! Contest Sponsored by Dremel

Hand Tools Only Contest

Participated in the
Hand Tools Only Contest

Be the First to Share

    Recommendations

    • Colors of the Rainbow Contest

      Colors of the Rainbow Contest
    • Maps Challenge

      Maps Challenge
    • Fandom Contest

      Fandom Contest

    4 Discussions

    0
    mkize410
    mkize410

    5 years ago

    May the 4th be wit u! cool sabes!

    0
    rstupplebeen
    rstupplebeen

    5 years ago

    I made similar for piñatas at a Jedi themed birthday party but yours look better. Nice job!

    0
    Flash67
    Flash67

    5 years ago

    They look pretty realistic. Thanks for sharing!