Paper Bird is a pendulum powered project. Move the box, even slightly, and the bird comes to life bobbing up and down.
Download the parts sheets here
You can download the parts for this project for free on the robives.com website here.
The download comes in both colour and line only for your own colour scheme. Print out the first two pages onto thin card. (230 micron / 230 gsm) The third page has only a few hinges. these need to be extra flexible so this page should be printed onto standard printer page. (80gsm)
Score along the dotted lines and carefully cut out the holes with a sharp knife before cutting out the parts.
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Glue together the three parts that make the body.
Fold up and glue together the body inner then glue it into place so that the back edge lines up with the small black dot on the outside of the body. (Arrowed)
Glue the wide hinge and one of the two small hinges into place as shown.
Assemble the legs then glue them to the wide paper hinge as shown. Make sure not to get any glue on the crease.
Glue the rest of the box into place.
Glue the box lid down.
Drop the pendulum into place in the hole in the top of the box and glue the hinge to the top of the box.
Fit the push rod between the pendulum and the bird.
Wrap two coins in some off-cuts of card. I used UK pieces. These are in diameter and weigh each.
Glue the coins to the end of the pendulum.
Glue the base to the box.
That's it! Taps the box and the bird will bob about pleasingly!
Participated in the
Make It Real Challenge