Paracord Snake Knot

Intro: Paracord Snake Knot

Step 1:

Start the bracelet off as you normally would.

Step 2:

Take the left strand and run it through the middle, and pull it tight.

Step 3:

Take the left strand and run it through the middle as you did with the right strand, and tighten it.

Step 4:

Repeat until you get to the end and it should look something like the picture. Once you are done finish it by tying an overhand knot, cutting excess cord, and fuse it with a lighter.

Share

    Recommendations

    • Electronics Tips & Tricks Challenge

      Electronics Tips & Tricks Challenge
    • Audio Contest 2018

      Audio Contest 2018
    • Furniture Contest 2018

      Furniture Contest 2018

    3 Discussions

    0
    None
    treesquatch

    2 years ago

    I believe this is the fishtail, not the snake knot

    0
    None
    WarMonkey45

    3 years ago

    Thank you! Yes I did make a black one.

    0
    None
    seamster

    3 years ago on Introduction

    Very nice and simple! Looks like your bracelet turned out great. Did you make a black one too?