Plant Watering System

Intro: Plant Watering System

This is a prototype model of a plant watering system.

Step 1: Step 1: Gather Materials

The pictures demonstrate the way the project should be completed.

Step 2: Step 2: Place Cylinder Under the Tube So It Is Filled.

The pictures demonstrate the way the project should be completed.

Step 3: Step 3: Place the Torus Above the Previous Shape Made in Step 2.

The pictures demonstrate the way the project should be completed.

Step 4: Step 4: Group Both the Torus and the Shape Made in Step 2. Use the Group Tool to Group and Highlight the Whole Figure.

The pictures demonstrate the way the project should be completed.

Step 5: Step 5: Find the Ball Connector and Get It Ready.

The pictures demonstrate the way the project should be completed.

Step 6: Step 6: Get the Ball Connector and Place It Inside the Figure to Create the Plant Watering System.

The pictures demonstrate the way the project should be completed.

Step 7: Step 7: Group the Object As It Is Shown in the Previous Steps. the Design Is Complete.

This is the finished product.

Share

    Recommendations

    • Electronics Tips & Tricks Challenge

      Electronics Tips & Tricks Challenge
    • Optics Contest

      Optics Contest
    • Plastics Contest

      Plastics Contest

    Discussions

    0
    None
    Penolopy Bulnick

    4 months ago

    Interesting design :) So, does the plant go in the middle and get watered through the sphere with the hole?