Start by gathering your materials...
-Hot Glue Gun
Step 1: Cut Out Two Pieces of Velcro...
Take your scissors and cut out 2 strips of Velcro. Then plug in your hot glue gun.
Step 2: Glue Velcro on Playstation
Take your hot glue and put it between the 1st and 2nd controller slots. (you can never have too much, the stronger the better)
Then glue on the top of the tray of your playstation as shown in many of the pictures.
Step 3: Finishing Up
Push your Velcro strips in the position which is where the disk tray will open and close.
"Remember to use common sense with the Velcro there are two sides of it!"
After you are finished let it sit for at least 30 minutes for the glue to harden.
Your all done now! Put it a game and play some old school classics!!!! Please like and share your thoughts in the comment section below!