Precision Cutting Board

About: I am a former furniture joiner turned opera singer, and I am doing my best to keep something else than just sound and hot air in my head. I like to figure out how things work, and i like to se if i can make ...

So this is basically just a drawing ready to be laser engraved and used as a cutting board. It is going to be a Christmas present for my brother and his girlfriend, so please don't tell them before after Christmas.

If you are new to laser cutting ask for help at your local Maker Space.

All of it was made in Inkscape in a couple of hours.

Share

    Recommendations

    • Remix Contest

      Remix Contest
    • Faux-Real Contest

      Faux-Real Contest
    • Warm and Fuzzy Contest

      Warm and Fuzzy Contest

    4 Discussions

    0
    None
    RasmusR2ClaudiaG54

    Reply 7 months ago

    I'm not sure I understand your question?

    0
    None
    RasmusR2Modern Rustic Workshop

    Reply 7 months ago

    So sorry. I somehow missed your comment. I did it on a thin piece of plywood that I glued to a thicker piece of plywood. Then I sanded the edges, oiled it with kitchen oil and gifted it away.