Pressure Sensor & Servo Prototype

Introduction: Pressure Sensor & Servo Prototype

This prototype is set up for a wearable project. When the pressure sensor is activated the servos move in unison.

Supplies:

  • 10k ohm resistor
  • (4) 9g Servos
  • Arduino Uno
  • Pressure Sensor
  • Jumper Wires
  • Breadboard

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Set Up Your Breadboard

Step 2: Set Up Your Code

And upload it to your Arduino!

Step 3: Begin Testing!

Be sure to check your servo to pin connections and that they match up with your code!

Be the First to Share

    Recommendations

    • Magnets Challenge

      Magnets Challenge
    • Raspberry Pi Contest 2020

      Raspberry Pi Contest 2020
    • Wearables Contest

      Wearables Contest

    Discussions