these are some print in place tech decks that are fairly fun to mess with, And they roll!! my suggestions is that if you are to print these, you should have the infill be at least be 50% so the axle does not snap when you are doing your tricks. this design was made in tinkercad. DO NOT print with supports!
Teacher Notes
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Supplies
- 3d printer
- filament
- slicing software
Participated in the
Skateboard Contest
Be the First to Share
Recommendations
Instrument Contest
Make it Glow Contest
STEM Contest
Discussions