Pro Watch Holder

About: College student perusing a degree in electrical engineering

This is a fun watch holder it is about 5.5 cm wide and 4 tall for the part the watch goes on if your wrist is bigger or smaller scale up or down respectivily. This is a link to download it on Thingaverse http://www.thingiverse.com/thing:846444

you will want to rotate it so the back is down when you print and you dont need support material all angles are 45 or less

Enjoy :)

Supplies:

Step 1: This Is What It Makes

Share

    Recommendations

    • Arduino Contest 2019

      Arduino Contest 2019
    • Party Challenge

      Party Challenge
    • IoT Challenge

      IoT Challenge

    Discussions