Project B

Introduction: Project B

About: My names John,I've been building with knex for 5 years And am currently working on a lever action tube fed shotgun =D

This is Project B. It uses a tubular mag underneath the gun that you load like a shotgun. It uses the same stock as Project A and shoots white rods.

Be the First to Share

    Recommendations

    • Puzzles Speed Challenge

      Puzzles Speed Challenge
    • Secret Compartment Challenge

      Secret Compartment Challenge
    • Lighting Challenge

      Lighting Challenge

    11 Discussions

    0
    tytiger33
    tytiger33

    8 years ago on Introduction

    I'd tell you to post it but you probably broke it up by now.

    0
    Johnhall44
    Johnhall44

    Reply 8 years ago on Introduction

    i take pics of the inside of the gun so i can rebuild it later so i just have to find the pics

    0
    beanieostrich

    What this gun needs is a whole new stock without the tiny thumb hole or even better, a properly angled handle. And your gun lacks a basic but very required part: a pin-guide.

    0
    DJ Radio
    DJ Radio

    Reply 8 years ago on Introduction

    A pin guide isn't required but definitely put something on it to make it easier to pull back.

    0
    Johnhall44
    Johnhall44

    Reply 8 years ago on Introduction

    I agree with you on the pin guide idea but I dont know if I'll have time to because im working on a clip fed shot gun that has an internal firing mech so you dont have to worry about a firing pi sticking out of the gun :D

    0
    dr. richtofen
    dr. richtofen

    Reply 8 years ago on Introduction

    mag-/magazine fed. A clip is something like you load into an KAR-98K, simonov SKS or m1 garand.
    It's pretty annoying when someone messes that up

    0
    Johnhall44
    Johnhall44

    Reply 8 years ago on Introduction

    its a mistake that is very confusing,because everyone is confused on the difference XD

    0
    dr. richtofen
    dr. richtofen

    Reply 8 years ago on Introduction

    mag-/magazine fed. A clip is something like you load into an KAR-98K, simonov SKS or m1 garand.
    It's pretty annoying when someone messes that up

    0
    Johnhall44
    Johnhall44

    Reply 8 years ago on Introduction

    Ya I know it needs a better stock, I was thinking about trying a m16 stock eventually but I dont know when I'll get to doing that....

    0
    Johnhall44
    Johnhall44

    8 years ago on Introduction

    dont just rate this without adding a comment on what I should do to improve this!!