Prototyping Switch

1,061

18

1

Introduction: Prototyping Switch

About: I am a Senior in college studying Mechanical Engineering. My interests include woodworking, 3D printing, electronics and building computers

I built this switch so that i could quickly and easily switch something on or off or test a circuit that didnt have a switch hard wired in yet.
It is built out of the case of a 9 volt battery then just 2 aligator clips hotglued to the sides. Its really simple but comes in really handy

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Electronics Tips and Tricks

Participated in the
Electronics Tips and Tricks

Hurricane Lasers Contest

Participated in the
Hurricane Lasers Contest

Pocket-Sized Contest

Participated in the
Pocket-Sized Contest

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge
    • Finish It Already Speed Challenge

      Finish It Already Speed Challenge

    Discussions