CNC - Punched Plastic Nut Jig

1,121

3

2

Introduction: CNC - Punched Plastic Nut Jig

About: Hello, I'm working at large scale high-tech company. As part of my responsibility, I provide professional support for most electrical & electronic development activities in the company: • Planning, impleme...

This jig was implemented after some mistake that have place
in harness connector size. 
The connector was wider than the gland nut (PG16) because of this,
it was impossible to thread it through the nut.
To resolve this problem I used Roland EGX-350 CNC machine
and office hole puncher. The concept was to load 2 plastic nuts on the tray
and punch them both in reason to save the time :)
The tray manually moves forward and back by handle.
All relevant parts were drawn in Dr.Engrave S/W (providing by Roland).
Polycarbonate 4mm was used as a  jig material.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Be the First to Share

    Recommendations

    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Rope & String Speed Challenge

      Rope & String Speed Challenge
    • Wearables Contest

      Wearables Contest

    2 Discussions

    0
    craftclarity
    craftclarity

    5 years ago on Introduction

    Looks like you did some troubleshooting on a production line...

    0
    FS2010
    FS2010

    Reply 5 years ago on Introduction

    Correct, it was mistake in planning of some harness...