Push Button Controlled LED

Introduction: Push Button Controlled LED

You will need - push button 1 , 5 white LEDs,4 greenLED ,1 RED LED Breadboard,5 male to male Jumper wires and Aduino UNO.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: You Will Need

  1. You will need - push button 1 , 5 white LEDs,4 greenLED ,1 RED LED Breadboard,5 male to male Jumper wires and Aduino UNO.

Step 2: Arduino Board Connected to Breadboard

1. one jumpear wire goes to GND and another one goes to 5v

2.connect the wire to any + and - in bread board

3.connect push button and LEDs as directed in the picture

Step 3: It Works !!!!

1. 4 jumper wires to be connected to breadboard as directed in the picture

did'nt see any arduno website to make this.I made it by myself.I made it by myself.I did not take the photo because the LEDs were too bright to take a photo.does it work???? Yes it works for me.

Hack Your Day Contest

Participated in the
Hack Your Day Contest

Raspberry Pi Contest 2016

Participated in the
Raspberry Pi Contest 2016

Be the First to Share

    Recommendations

    • Snow Challenge

      Snow Challenge
    • Magnets Challenge

      Magnets Challenge
    • Shelving Contest

      Shelving Contest

    2 Discussions

    0
    arduino_bot1
    arduino_bot1

    8 months ago

    cool!
    not being rude but there is no need of arduino to do this
    you can just connect this to a 5v power source and it will just work fine...
    but anyways...nice job